Bike Repair Service

Mechanical trouble shooting would entail identifying issues that arise due to internal mechanical components that either fail or may have been dislodged during the functioning of the motorcycle which would either need to be repaired due to wear and re-installed if the wear is not as severe or completely replaced due to the wear being so severe that it cannot function within its original parameters.

Electrical troubleshooting would entail identifying any and all faults in the wiring and electrical systems of the motorcycle and rectifying the same by replacing the wiring sections and reinforcing the repair using extra sleeves in order to guard against future damage and faults that could occur at the same points.

Electronic troubleshooting entails running a full diagnostic of the motorcycles computer control module in order to ascertain if there are any fault-codes present in the system. If there are any fault codes we then proceed to verify the component that is causing the fault code. Once the component is identified it is then checked to see if the component can be repaired or needs to be replaced. Once the component is either repaired or replaced based on its condition the fault code will be cleared from the system. Thus by this systematic procedure any and all issues causing fault codes in the electronic systems are identifies and rectified.