ULTRA BOND – TILES JOINT FILLERS –UF-110ULTRAFILL- UF110 - As these high-performance grouts are highly modified, it allows to add other benefits such as quickercuring, reduced shading, and efflorescence control and smooth finish of all types of Tiles, marbles & Granites Joints.Polymer modified grout Good compression strength Suitable for 1-6mm joints Available in a range of colors.Product Description: ULTRAFILL- UF110 CEMENT POLYMER GROUT: Single component, polymer modified, water resistant,cement polymer grout. The properties are as follows:Joint width : 2-6mm Pot life @27±10C : 30 minCuring time @27±10C : 24 Hrs Specific gravity : 1.7 Temperatureresistance : -300C to 1500C Compressive Strength : 4.00 KN (24 Hrs min)All installed tiles area shall be allowed to cure and dry for 7 days. Joints shall be cleaned and made free from all dirt, dust,efflorescence, laitance and other contaminants. All tiles shall be checked for soundness and good bond with the adhesivebed and substrate, if found bad, tiles shall be removed including bed adhesive and new reinstalled and allowed to cure anddry completely.Joint Grouting - All tile joints shall be grouted using ULTRAFILL- UF-110 Cement Polymer Grout Mix the 3 part ULTRAFILLUF-110 Cement Polymer Grout powder and 1 part of clean water until a lump free smooth paste of uniform colour isobtained, using heavy duty slow speed (less than 300 rpm) electrical drilling machine with spiral paddle attached. Thus,obtained mix has 30 min of pot life.In case of using RP-3 POLYMIX, 175 ML with mix with 1Kg grout powder. Using a grout float or rubber squeeze compact thegrout into the joint ensuring that they are completely filled, remove excess grout as much as possible from the surface oftiles. Use sponge or sponge-board, dampened in clean water to clean the surface of tile diagonally. Allow about 15 min forgrout to dry. Finally, wash down with clean water with sponge / sponge board to remove un-dried grout film from thesurface. Once the grout has sufficiently set, polish the surface with clean cloth. Do not apply in damp condition.Shelf Life:Factory sealed bags of this product are guaranteed to be of first quality 18 months* if stored off the ground in a dry area, at21C and 50% RH. *High humidity will reduce the shelf life of bagged product.