Biscuit Brown Solvent Base Heat Resistant & Thermal Insulation Paint For 1200 Deg C- SB, Roller, Metal

Excellent Product for Energy Saving Upto 1200 Deg C SOLVENT BASE

Based on the heat resistant medium and after adding special additives and ceramic microspheres, UGAM thermal insulation coatings are manufactured for energy saving due to reducing heat losses from ovens, furnaces or refrigerators. These microspheres are used in manufacturing tiles used for exterior cladding of space shuttle. These coatings reduce energy from 10 to 20 percent in practical. The selection of coating is same as heat resistant coating selection. These coatings are named as UGAM INSULMIX, UGAM H R T I 200, UGAM H R T I 400, UGAM H R T I 600, UGAM H R T I 1200 and UGAM H R T I 1800.


UGAM HRTI 1200 SB SYSTEM:
This Paint work upto 1200 Deg C to reduce heat losses in atmosphere as well as for ENERGY SAVING. Please go through below details if temperature of your ovens, furnace, steam pipelines, boilers and where heat is used for process upto 1150 Deg C.

Description :
This product is used to the surface of boiler where the temperature is more than 600 degrees C and less than 1100 degrees C. This is suitable product for application on metal surfaces. For application over bricks, our water base product should be used. This is used for reduction in energy consumption of furnaces due to heat losses.This product is also suitable for brick hangers in furnace ceiling, furnace doors, any metal area behind bricks which can be exposed to excessive heat in case of bricks being damaged or leaked through. In industries where heat is used for process, UGAM Thermal Insulation Coatings are used for energy saving purpose up to 1800 degrees C. Ugam H R T I 1200 Coating is specially manufactured for coating of parts of furnaces which come into contact of heat upto 1200 deg. Celsius. This coating increases the life of parts of furnace or the parts on which they are applied for protection by providing thermal insulation to them by radiation control.

Application Procedure:
Ugam H R T I 1200 Coating is specially manufactured for coating of parts of furnaces which come into contact of heat upto 1200 deg. Celsius. This coating increases the life of parts of furnace or the parts on which they are applied for protection by providing thermal insulation to them by radiation control. The application procedure of UGAM H R T I 1200 is very easy. It can be applied by brush after mixing it well and thinned down to application viscosity if required. It does not need any primer. The previously applied coating should be removed from the surface by UGAM PAINT STRIPPER. The paint stripper should be applied to the surface and left for few minutes till the paint starts lifting from the surface. Then the surface should be scraped lightly with the help of emery paper. The surface should then be cleaned by thinner followed by application of first coat of UGAM H R T I 1200. The surface should be air-dried for one hour and then should be heated and maintained to 250 deg Celsius for one hour. Then the second coat should be applied in similar way and cured again at 250 deg C for one hour. Then the third coat should be applied and cured as first two coats. After final coating, the surface should be brought to ambient temperature and then in first heating the temperature should be raised @ 100 deg C per hour. You may get some fumes while first heating. It is normal as convertible medium reaction releases these fumes.

The covering per litre is around 100 sq. ft. per coat depending upon the absorption by the surface.

The technical specification is correct to the best of our knowledge and under test conditions and we do not accept any liability towards misuse and contents of it. Product must be tested for specific use prior to use.