Shreemay Enterprises

Product Description

Professional version of the Pro Mini is a micro controller circuit board. It has 20 digital input/output pin (six of them can be used as a PWM output), 8 analog input, a 16MHZ resonator, a reset button, the installation hole lead foot.

Features

• 14 Digital input/output port RX and TX, D2 ~ D13
• 8 Analog input port A0 ~ A7
• 1 Pair of TTL level serial port transceiver port RX / TX
• 6 PWM port, D3, D5, D6, D9, D10, D11
• Using Atmega328P – AU microcontroller
• Support serial download
• Support for external 5 V ~ 12 V dc power supply
• Support 9v battery powered
• 16 MHZ clock frequency

Package Includes

• 1 x Pro Mini ATMEGA328P 5V/16M Improved Version Module

Other Details:-

• The L293D Motor Driver/Servo Shield for Arduino is probably one of the most versatile on the market and features 2 servo and 4 motor connectors for DC or stepper motors. That makes it a great shield for any robotic project.
• This Arduino compatible motor Driver shield is a full-featured product that it can be used to drive 4 DC motor or two 4-wire steppers and two 5v servos. It drives the DC motor and stepper with the L293D, and it drives the servo with Arduino pin9 and pin10.
• The shield contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction of the motor drivers. The output enables the L293D is directly connected to the PWM outputs of the Arduino.

Product Description

The TM1637 4 Digits 7 Segment Led Display Module with Clock for Arduino is an affordable solution for displaying the output data of your Arduino project. Though the data displayed is restricted by numbers still it allows users to display some characters too like A, B, C etc.

This 7 segment LED Display has 4 digits which are controlled by TM1637 Driver Chip. It requires only two connections to control this TM1637 4 Digits 7 Segment Led Display Module. Also thanks to the I2C Bus you can control it using only 2 wires, leaving more pins available on your Microcontroller to connect other things.

The module is a 12-foot clock with four common anode tube (0.36 inch) display module for driver IC TM1637, only two signal lines can make the MCU control four 7-segment digital tubes.

Pinout Description of TM1637 4 Digits 7 Segment Led Display Module with Clock for Arduino :-

• GND    –    GND
• VCC      –    5V
• DIO     –     D2
• CLK     –     D3

Features

• Ease to use.
• Ease of multiplexing.
• Can use as a 4 digit display unit.
• Can use as a clock display.
• DIY clock project.
• 4 digit display unit.
• Electrical/Electronic projects.
• The counter project using 7 segment display.
• 4 M2 screws positioning holes for easy installation

Package Includes

• 1 x 4 Bits Digital Tube LED Display Module.