Wacker Neuson Equipment Private Limited

Brand	Wacker Neuson
Weight	15.5 kg
Model Name/Number	P35A
Width	889 mm
Engine Motor	Air-cooled single-cylinder four-cycle gasoline engine
Displacement	35.8 cm cube
Engine Performance	1.0 (1.3) kW (hp)
Length	1,117 mm

When finishing concrete floors Wacker Neuson's wet screed carries out three working processes in one: spreading, screeding and compacting. Not only is this extremely practical, the device is also very easy to use. The carrying handles make it easy to move the P35A over the concrete and delivers first-class results in the process. It is suitable for all kinds of concrete, because the centrifugal force is adjustable to 7 positions

• Extremely mobile device concept
• Easy to operate:
• Encapsulated eccentric casing to protect from dirt, concrete and splash water

The right length of profile for every operation

The profile lengths for the wet screed P 35A is available between 120 and 490 cm, depending on the size of the area to be screeded. 

Brand	Wacker Neuson
Beam Width	355 mm
Length	1.5 m
Model Name/Number	HP50A
Weight	55 kg
Height	475 mm
Tank Capacity	3.7 l
Operating Performance	3.5kW

Vibratory truss screeds are designed for precise strike-off and consolidation of concrete surfaces up to 25 cm/10 inches thick where critical flatness is desired. The bolted construction throughout the screed sections allow for fast assembly without special tools. The T-bolt adjuster provides quick, precise adjustments for flat, crowned or inverted strike-off.

• Winch system consists of two cranks located on the same end of the screed for one-person operation.
• Lightweight, high strength aluminum truss for reduced weight and easy machine handling.
• Connector plate with greaseable flange bearing provides rigidity for even vibration and fast assembly of sections.
• Eccentric weights are located near the shaft bearings to prevent shaft whip and extend bearing life.
• Fully self-contained unit will run on any form such as pipe, wood, block or metal.